Эротические рассказы

GTO Data and ID Guide: 1964-1974. Pete SesslerЧитать онлайн книгу.

GTO Data and ID Guide: 1964-1974 - Pete Sessler


Скачать книгу
Casting Number 389-ci all 77

       Carburetors

      The part number for the 1965 Carter AFB 4-barrel carburetor was found on a metal tag mounted on the carburetor air horn. For the Tri-Power carbs, the numbers were stamped on a plate and mounted on one of the carburetor mounting screws.

The 4-speed manual Tri-Power setup received a mechanical linkage that actuated the two end carbs; automatic cars were vacuum equipped. This car has a dealer-installed Ram-Air setup. (Thomas Short Photo)

       The 4-speed manual Tri-Power setup received a mechanical linkage that actuated the two end carbs; automatic cars were vacuum equipped. This car has a dealer-installed Ram-Air setup. (Thomas Short Photo)

       Distributors

      The 1965 distributors had the part number stamped and mounted around the distributor shaft.

       Intake Manifolds

      On 4-barrel engines, the part number is stamped or cast into an intake runner. On Tri-Power manifolds, it can be found on the center and rear intake runners.

Engine Part Number
4-barrel 9778816
3×2-barrel 9778818

       Exhaust Manifolds

      The part number for the exhaust manifolds is generally, but not always, found on the outer face of the manifold.

Location Part Number
Driver’s side 9779032
Passenger’s side 9779325

      The transmission codes are:

      On the Super Turbine 300 2-speed automatic, the transmission code was stamped on the low-servo cover on the passenger’s side of the transmission or on a metal tag.

      The 3- and 4-speed M20 and M21 manual transmissions were used on the GTO and, generally, but not always, had the part number stenciled on the transmission case on the driver’s side of the case, at the rear of the cover. The code number indicated the type of transmission and the production date.

      An identification code is marked in yellow paint on top of the case on 4-speed transmissions: W stands for wide-ratio and 9 stands for close-ratio. On the 3-speed Tempest (Muncie), the letter X indicates a heavy-duty Muncie and is marked on the passenger’s side of the case. The letter S identifies a midyear (March 1) introduction of the 3-speed manual Dearborn transmission.

      In 1965, differential codes were stamped on the back passenger-side axle tube. The codes identify which axle ratio was used and if the axle was equipped with Safe-T-Track.

      The GTO has the following items as standard and were not available on other LeMans models: the vinyl-trimmed assist bar over the glove box door, a GTO emblem located to the left of the assist bar, and a GTO emblem mounted on each door.

      Exterior color codes can be found on the cowl data plate located on the driver’s side of the firewall.

The hardtop and coupe were also very stylish, especially with the Cordova vinyl roof. Note the 6.5 emblem on the front fender, while the GTO was placed on the rear fender.

       The hardtop and coupe were also very stylish, especially with the Cordova vinyl roof. Note the 6.5 emblem on the front fender, while the GTO was placed on the rear fender.

      Typically, the dealer’s parts department sold these and other parts based on current market trends. They were designed to increase motoring pleasure.

      • Tonneau cover

      • Roof luggage carrier

      • Trunk ski and luggage carrier

      • Locking gas cap

      • Spare tire lock

      • Enclosed Car Pak roof luggage carrier

      • Guide-Matic headlamp control

      • Seat belt retractors

      • Ram-Air pan

      • Wire wheel discs

      • Tissue dispenser

      • Engine block heater

      • Car compass

      • Vacuum gauge

       Special Equipment

       Option Groups

      Compiling multiple options into a single option group was a way of creating less confusion and paperwork for dealers.

Скачать книгу
Яндекс.Метрика